ConnectCNC

DNC / file transfer settings for Cincinnati Acramatic 850

Set the following parameters on the machine:

Parameter	Value
Baud rate	9600
Parity	None
Data bits	8
Stop Bits	1

Some of the above settings seem to conflict with those in ConnectCNC;
but the control counts the even parity bit as a data bit.

Set ConnectCNC as follows:

Common Settings
Name	Acramatic 950
Baudrate	9600
Data bits	7
Stop bits	1
Parity	Even
Flow control	Xon/Xoff
Xon Char.	17
Xoff char.	19
Port	as available

Send Settings
Header String	0
Trailer String	0
End of Line Sequence
Recognize custom EOL
Replace

Check "%" character	Checked. This control requires a "%" at the beginning and end of your programs.
Skip empty lines	user's choice
Skip line numbers	user's choice
Skip non printable bytes	user's choice
Skip comments	check "(...)" if required
Default folder	Folder in which you store this machine's programs
Start transfer delay	user's choice

Receive Settings
Header String	0
Trailer String	10
End of Line Sequence
Recognize custom EOL
Replace (checked)	13,10

Check "%" character	Checked. This control requires a "%" at the beginning and end of your programs.
Skip empty lines	user's choice
Skip line numbers	user's choice
Skip non printable bytes	user's choice
Skip comments	check "(...)" if required
Default folder	Folder in which you store this machine's programs
Start transfer delay	user's choice

Cable Pin Out

Cable pinout for connecting Cincinnati Acramatic 850

Sometimes file transfer will not run, even if all the settings are correct. The following procedure may correct the problem, especially if you're running the machine via DNC: Check to make sure your FIFO buffers disabled on the PC. You access the settings in Control Panel -> System -> Hardware tab -> Device Manager. Find your COM ports and double click the one you are communicating with. Click the tab for Port Settings then Advanced. Uncheck the FIFO buffers. Having this turned on can cause problems with RS232 transfer, especially DNC.
Once you have ConnectCNC and your CNC machines communicating, we strongly suggest you take the following precautions: - Download some programs, the longer the better, from your CNC to the pc. Save them under a temporary filename so you don't overwrite the original files. Examine them for errors such as dropped or changed text. Do this for the first few programs that you use.
These settings have been collected from users of our software and machine tool distributers. We have listed them to help users of ConnectCNC to communicate between their computers and CNC controls. Since we have no control over the many variables involved, including such things as cable conditions, modifications to machines, condition of computer hardware, etc., we take no responsibility for any damage caused to programs or machines through the use of this software.

System requirements:
Any computer with Windows95(32 bit), 98, ME, 2000 XP, NT, Vista, Win7 & 8 (32 or 64 bit).
ConnectCNC requires at least one serial COM port, or USB/RS232c port converter.