ConnectCNC

DNC / file transfer settings for Fadal88

Set the following parameters on the machine:

To set the CNC up for drip feed:
Input the code "DNC" via MDI at the control.

Set ConnectCNC as follows:

Common Settings
Name	Fadal 88
Baudrate	9600
Data bits	7
Stop bits	1
Parity	Even
Flow control	Xon/Xoff
Xon Char.	17
Xoff char.	19
Port	as available

Send Settings
Header String	84,65,44,49
Trailer String
Your program must have the percent sign at the beginning and end.
End of Line Sequence
Recognize custom EOL
Replace

Check "%" character	checked
Skip empty lines	user's choice
Skip line numbers	user's choice
Skip non printable bytes	user's choice
Skip comments	check "(...)" if required
Default folder	Folder in which you store this machine's programs
Start transfer delay	user's choice

Receive Settings
Header String
Trailer String
End of Line Sequence
Recognize custom EOL
Replace (checked)	13,10

Check "%" character	checked.
Skip empty lines	user's choice
Skip line numbers	user's choice
Skip non printable bytes	user's choice
Skip comments	check "(...)" if required
Default folder	Folder in which you store this machine's programs
Start transfer delay	user's choice

Cable Pin Out

Cable pinout for connecting Fadal 88

Sometimes file transfer will not run, even if all the settings are correct. The following procedure may correct the problem, especially if you're running the machine via DNC: Check to make sure your FIFO buffers disabled on the PC. You access the settings in Control Panel -> System -> Hardware tab -> Device Manager. Find your COM ports and double click the one you are communicating with. Click the tab for Port Settings then Advanced. Uncheck the FIFO buffers. Having this turned on can cause problems with RS232 transfer, especially DNC.
Once you have ConnectCNC and your CNC machines communicating, we strongly suggest you take the following precautions: - Download some programs, the longer the better, from your CNC to the pc. Save them under a temporary filename so you don't overwrite the original files. Examine them for errors such as dropped or changed text. Do this for the first few programs that you use.
These settings have been collected from users of our software and machine tool distributers. We have listed them to help users of ConnectCNC to communicate between their computers and CNC controls. Since we have no control over the many variables involved, including such things as cable conditions, modifications to machines, condition of computer hardware, etc., we take no responsibility for any damage caused to programs or machines through the use of this software.

System requirements:
Any computer with Windows95(32 bit), 98, ME, 2000 XP, NT, Vista, Win7 & 8 (32 or 64 bit).
ConnectCNC requires at least one serial COM port, or USB/RS232c port converter.