ConnectCNC settings for Mitsubishi 300

ConnectCNC - CNC file transfer and DNC software

ConnectCNC home EditCNC home

DNC / file transfer settings for Mitsubishi 300-500

Set the following parameters on the machine:
IO device parameters

Parameter	Value
2	2
3	3
4	0
5	1
6	3
7	3
11	3
12	1

IO parameters screen #2

Parameter	Value
1	1
2	1
3	0
6	0
7	200

Set ConnectCNC as follows:

Common Settings
Name	Mitsubishi 300
Baudrate	4800
Data bits	8* see note
Stop bits	2
Parity	even
Flow control	Xon/Xoff
Xon Char.	17
Xoff char.	19
Port	as available

*Note: If you get a parity error with this setting change the 8 to 7.

Send Settings

Header String

Trailer String

End of Line Sequence

Recognize custom EOL

Replace

Check "%" character unchecked

Skip empty lines user's choice

Skip line numbers user's choice

Skip non printable bytes user's choice

Skip comments check "(...)" if required

Default folder Folder in which you store this machine's programs

Start transfer delay user's choice

Receive Settings

Header String

Trailer String

End of Line Sequence

Recognize custom EOL

Replace checked 13,10

Check "%" character checked if you have a "%" at the beginning and end of your programs.

Skip empty lines user's choice

Skip line numbers user's choice

Skip non printable bytes user's choice

Skip comments check "(...)" if required

Default folder Folder in which you store this machine's programs

Start transfer delay user's choice

Cable Pin Out

Once you have ConnectCNC and your CNC machines communicating, we strongly suggest you take the following precautions: - Download some programs, the longer the better, from your CNC to the pc. Save them under a temporary filename so you don't overwrite the original files. Examine themfor errors such as dropped or changed text. Do this for the first few programs that you use.
These settings have been collected from users of our software and machine tool distributers. We have listed them to help users of ConnectCNC to communicate between their computers and CNC controls. Since we have no control over the many variables involved, including such things as cable conditions, modifications to machines, condition of computer hardware, etc., we take no responsibility for any damage caused to programs or machines through the use of this software.

Site Map ©Copyright CNC Consulting Inc. 1996-2008
Minimum system requirements for our software: Any computer with Windows95 v950B or higher(32 bit), 98, ME, 2000 XP, NT, Vista. Hardware requirements will depend on the size of CNC files processed with EditCNC and ConnectCNC. However, ConnectCNC requires at least one serial COM port, or USB/RS232c port converter.